What should be noted in the assembly process of other
Hydraulic Components of the hydraulic system? Dalan Hydraulic Xiaobian will discuss it with you!
What should be noted in the assembly process of other hydraulic components of the hydraulic system? Dalan Hydraulic Xiaobian will discuss it with you! The specific matters to be noted are as follows:
1. All hydraulic components must be tested for pressure and sealing, and can be installed after passing the test.
2. Various automatic control instruments should be checked before installation to avoid mistakes.
3. When the
Hydraulic Pump is installed, its rotation direction and inlet and outlet ports should meet the technical requirements.
4. The oil absorption height of all kinds of hydraulic pumps is generally less than 0.5mm.
5. The deviation of the hydraulic pump drive shaft and the motor drive shaft should be less than 0.1 mm, and the flexible coupling is generally used.
6. It is not allowed to directly drive the pump shaft to rotate with the tape, so as to prevent the pump shaft from being subjected to excessive radial force, which affects the normal operation of the pump.
7. When installing various control valves, pay attention to the orientation of the oil inlet and return port.
8. When installing the valve parts with flanges, the screws cannot be tightened too tightly, and too tight may cause poor sealing.
9. Install the
Hydraulic Cylinder should be firm and reliable. To prevent the thermal expansion, when the stroke is large and the temperature is high, one end of the cylinder must remain floating.
10. The sealing ring of the hydraulic cylinder should not be too tight, especially the U-shaped ring, so as to avoid excessive resistance.
----- Editor-in-Chief: Dalan Oil Pump Motor 02-Procurement Consultant
Copyright http: / (Dalan Motor) Reprint, please indicate the source
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Yantai Tianbing Construction Machinery Co., Ltd
January 13, 2023
